Rear Brake Caliper - Honda CBR125R Owner's Manual

INSTALLATION
Install the brake caliper/bracket assembly to the
right fork leg.
Install new mounting bolts and tighten them to the
specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the brake hose eyelet between the stoppers
with brake hose oil bolt and new sealing washers.
Tighten the brake hose oil bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the brake pads (page 15-8).
Fill the reservoir to the upper level and bleed the
front brake system (page 15-6).

REAR BRAKE CALIPER

REMOVAL
Drain the brake fluid from the hydraulic system
(page 15-5).
Remove the brake pads (page 15-9).
Remove the brake hose oil bolt and sealing wash-
When removing the
ers.
oil bolt, cover the
end of brake hose
Remove the rear wheel (page 14-5).
to prevent
Remove the brake caliper/bracket assembly from
contamination.
the swingarm.
DISASSEMBLY
Remove the following:
– Caliper bracket
– Pin boots
– Pad spring
HYDRAULIC BRAKE
BOLTS
OIL BOLT
SEALING OIL BOLT
WASHERS
CALIPER/BRACKET
BRAKE HOSE
ASSEMBLY
BRACKET
STOPPERS
SEALING
WASHERS
PAD SPRING
PIN BOOTS
15-23