Honda CBR125R Owner's Manual page 150

FUEL SYSTEM (PGM-FI)
THROTTLE VALVE FULLY CLOSED
POSITION RESET PROCEDURE
• If the sensor unit is removed, reset the throttle
valve fully closed position as following.
1. Lift and support the fuel tank (page 3-6).
2. Clear the DTC's (page 5-12).
3. Turn the ignition switch OFF.
4. Remove the dummy connector.
5. Short the DLC using a special tool.
TOOL:
SCS connector
6. Disconnect the ECT sensor 3P connector.
Short the ECT sensor 3P connector terminals of
the wire harness side using a jumper wire.
Connection: Yellow/blue – Green/orange
7. Turn the ignition switch ON (and engine stop
switch " ": CM and U type).
Disconnect the jumper wire while the MIL blink-
ing (within 10 seconds).
8. After disconnection of the jumper wire, the MIL
start to blinking.
5-58
070PZ-ZY30100
ECT SENSOR 3P CONNECTOR
JUMPER WIRE
DLC
SCS CONNECTOR
Y/Bu
G/O
MIL