Honda CBR125R Owner's Manual page 185

Loosen the water hose band screws and disconnect
the water hoses.
Disconnect the O
Do not disconnect
and spark plug cap.
the O sensor cap
2
from the O sensor.
2
If the O
2
sensor cord with a new one.
Release the rubber cap.
Remove the starter motor terminal nut and starter
motor cable.
Remove the starter motor mounting bolt and
ground cable.
Support the engine using a jack or other adjustable
The jack height
support to ease of engine hanger bolts removal.
must be continually
adjusted to relieve
Remove the following:
stress for ease of
– Front engine hanger bolt and nut
bolt removal.
– Front engine hanger plate bolts
– Front engine hanger plates
sensor 2P (Natural) connector
2
sensor cap is disconnected, replace the O
ENGINE REMOVAL/INSTALLATION
WATER HOSES
BAND SCREWS
SPARK PLUG CAP
2
2P (NATURAL) CONNECTOR
BOLT STARTER MOTOR CABLE
GROUND CABLE
BOLTS
BOLT/NUT
RUBBER CAP
NUT
HANGER PLATES
7-5