Honda CBR125R Owner's Manual page 306

FRONT WHEEL/SUSPENSION/STEERING
Set the fork slider in a vise with a piece of wood or
Do not over-tighten
soft jaws to avoid damage.
the vise on the fork
slider.
Install a new sealing washer to the fork socket bolt.
Apply locking agent to the fork socket bolt threads
and install it.
Tighten the fork socket bolt to the specified torque.
If the fork piston
turns with the
TORQUE: 20 N·m (2.0 kgf·m, 15 lbf·ft)
socket bolt,
temporarily install
the fork spring,
spring seat, spring
collar and fork bolt.
Pour the specified amount of recommended fork
fluid into the fork pipe.
RECOMMENDED FORK FLUID (Except CM type):
Honda ULTRA CUSHION OIL 10W or equivalent
RECOMMENDED FORK FLUID (CM type only):
Pro Honda Suspension Fluid SS-8 (10W) or equiv-
alent
FORK FLUID CAPACITY:
206 ± 2.5 cm
Slowly pump the fork pipe several times to remove
any trapped air from the lower portion of the fork
pipe.
Compress the fork pipe fully and measure the fluid
level from the top of the fork pipe.
FLUID LEVEL: 131 mm (5.2 in)
Pull the fork pipe up and install the fork spring with
the tightly wound coil side facing down.
Install the spring seat and spring collar.
13-24
(7.0 ± 0.08 US oz, 7.3 ± 0.09 Imp oz)
2
SEALING WASHER
BOLT
COLLAR
SEAT
SPRING
DOWN
BOLT
131 mm
(5.2 in)