FUEL SYSTEM (PGM-FI)
AIR CLEANER HOUSING
REMOVAL/INSTALLATION
Remove the air cleaner element (page 3-8).
Disconnect the crankcase breather hose.
Loosen the connecting hose band screw.
Disconnect the fuel tank drain hose.
Release the fuel feed hose and fuel pump wire from
the hose guides of the air cleaner housing.
Remove the bolts and air cleaner housing.
Installation is in the reverse order of removal.
Route the hose and
wire properly (page
1-18).
THROTTLE BODY
REMOVAL
Relieve the fuel pressure and disconnect the quick
connect fitting (page 5-44).
Remove the air cleaner housing (page 5-52).
Disconnect the sensor unit 5P (Black) connector.
5-52
BAND SCREW
DRAIN HOSE
BOLTS
FUEL PUMP WIRE
AIR CLEANER HOUSING
5P (BLACK) CONNECTOR
BREATHER HOSE
FEED HOSE