Honda CBR125R Owner's Manual page 321

Remove the damper rubbers and O-ring.
Remove the driven sprocket nuts.
Remove the driven flange collar.
Drive out the driven flange bearing.
Install the bearing remover head into the bearing.
From the opposite side, install the bearing remover
shaft and drive out the bearing from the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover head, 12 mm
Bearing remover shaft
07746-0050300
07746-0050100
REMOVER HEAD
REAR WHEEL/SUSPENSION
DAMPER RUBBERS
NUTS
COLLAR
BEARING
REMOVER SHAFT
O-RING
14-7