Water Pump - Honda CBR125R Owner's Manual

Connect the fan motor 2P (Natural) connector.
Close the rubber sheet.
Install the trim clip.
Install the middle cowl (page 2-9).
Remove the suitable support and close the fuel tank
(page 3-6).
Fill the system with the recommended coolant
(page 6-6).

WATER PUMP

SEALS INSPECTION
Remove the lower cowl (page 2-8).
Check for signs of seal leakage.
If water leaks through the bleed hose, replace the
mechanical seal (page 6-15).
If oil leaks through the bleed hose, replace the oil
seal (page 6-15) .
A small amount of "weeping" from the bleed hose is
normal.
REMOVAL/DISASSEMBLY
Drain the coolant (page 6-7).
Remove the bolts, drain bolt, sealing washer, water
pump cover and O-ring.
COOLING SYSTEM
2P (NATURAL) CONNECTOR
TRIM CLIP
O-RING
BOLTS DRAIN BOLT/SEALING WASHER
RUBBER SHEET
BLEED HOSE
COVER
6-15