Front Brake Caliper - Honda CBR125R Owner's Manual

HYDRAULIC BRAKE
Install the master cylinder to the brake pedal and
install the joint pin and new cotter pin.
Install the right step holder assembly and step
holder mounting bolts.
Tighten the step holder mounting bolts to the speci-
fied torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Tighten master cylinder mounting bolts.
Install the brake hose eyelet with the brake hose oil
bolt and new sealing washers.
Push the brake hose eyelet joint against the stopper,
then tighten the brake hose oil bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill the reservoir to the upper level and bleed the
rear brake system (page 15-6).

FRONT BRAKE CALIPER

REMOVAL
Drain the brake fluid from the hydraulic system
(page 15-5).
Remove the brake pads (page 15-8).
Remove the brake hose oil bolt, sealing washers
When removing the
and brake hose eyelet.
oil bolt, cover the
end of brake hose
Remove the brake caliper mounting bolts and brake
to prevent
caliper/bracket assembly.
contamination.
15-20
COTTER PIN
MASTER CYLINDER
MOUNTING BOLTS
STEP HOLDER ASSEMBLY
STOPPER
BRAKE HOSE
OIL BOLT
SEALING WASHER
JOINT PIN
STEP HOLDER
MOUNTING BOLTS
OIL BOLT
SEALING WASHERS
BOLTS
CALIPER/BRACKET
ASSEMBLY