Honda CBR125R Owner's Manual page 142

FUEL SYSTEM (PGM-FI)
INSPECTION
Check the fuel pump unit for wear or damage,
replace it if necessary.
Check the fuel filter for wear or damage.
Apply engine oil to the fuel tank contacting area of
the fuel pump.
INSTALLATION
Install a new packing onto the fuel pump unit.
Always replace the
packing with a new
one. Be careful not
to pinch the dirt and
debris between the
fuel pump unit and
packing.
Install the fuel pump unit into the fuel tank.
Be careful not to
damage the fuel
level sensor float
arm.
When installing the setting plate onto the fuel pump
unit, align the following:
– Slots of the fuel pump setting plate and tabs of
the fuel pump unit
– " " marks of the fuel pump setting plate and fuel
tank
Install the nuts and clamp.
Tighten the fuel pump nuts to the specified torque
in the specified sequence as shown.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the quick connect fitting (page 5-46).
Route the pump
Install the fuel tank (page 5-51).
unit wire properly
(page 1-18).
5-50
FUEL PUMP UNIT
PACKING
" " MARKS
PLATE Align
CLAMP
(1)
(6)
(4)
(2)
FUEL FILTER
FUEL PUMP UNIT
NUTS
(3)
(5)