Honda CBR125R Owner's Manual page 291

Tighten both handlebar pinch bolts to the specified
torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the stopper rings to the grooves of both fork
pipes.
Clean the inside surface of the handlebar grip and
outside surface of the handlebar and throttle pipe.
Apply Honda Bond A or equivalent to the inside sur-
face of the grips and to the clean surface of the left
handlebar and throttle pipe.
Wait 3 – 5 minutes and install the grip.
Allow the adhesive
Rotate the grips for even application of the adhe-
to dry for 1 hour
sive.
before using.
Install the left handlebar switch housing while align-
ing the locating pin in the housing with the hole in
the handlebar.
Install the screws and tighten the forward screw
first, then tighten the rear screw.
FRONT WHEEL/SUSPENSION/STEERING
STOPPER RING
Align
BOLT
LEFT HANDLEBAR
SWITCH HOUSING
SCREWS
13-9