Honda CBR125R Owner's Manual page 138

FUEL SYSTEM (PGM-FI)
QUICK CONNECT FITTING
INSTALLATION
• Always replace the retainer of the quick connect
fitting when the fuel feed hose is disconnected.
• If any retainer needs replacing, use the same
manufacturer's retainer as the ones being
removed (The various manufactures feature dif-
ferent retainer specifications).
• If any damage or cut-out on the rubber cap or
connector damper, replace it with a new one.
• Do not bent or twist fuel feed hose.
1. Insert a new retainer into the connector.
• Align new retainer locking pawls with the con-
nector grooves.
2. Set the rubber cap as shown.
Then press the quick connect fitting onto the
pipe until both retainer pawls lock with a
"CLICK".
• Align the quick connect fitting with the pipe.
If it is hard to connect, put a small amount of
engine oil on the pipe end.
3. Make sure the connection is secure and that the
pawls are firmly locked into place; check visually
and by pulling the connector.
4. Make sure the rubber cap is in place (between
the retainer tabs).
5-46
CONNECTOR Align
LOCKING PAWLS
CONNECTOR
RETAINER TABS
CONNECTOR
RETAINER
RUBBER CAP