Honda CBR125R Owner's Manual page 298

FRONT WHEEL/SUSPENSION/STEERING
Install the bearing remover head into the bearing.
From the opposite side, install the bearing remover
shaft and drive out the bearing from the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover head, 12 mm
Bearing remover shaft
ASSEMBLY
42 N·m (4.3 kgf·m, 31 lbf·ft)
BRAKE DISC
DUST SEAL
Drive in a new right side bearing squarely with its
Never install the old
marked side facing up until it is fully seated.
bearing, once the
bearing has been
Install the distance collar.
removed, the
Drive in a new left side bearing squarely with its
bearing must be
marked side facing up until it is seated on the dis-
replaced with new
tance collar.
ones.
TOOLS:
Driver
Attachment, 37 x 40 mm
Pilot, 12 mm
13-16
07746-0050300
07746-0050100
BEARING (6301UU)
BEARING (6301UU)
07749-0010000
07746-0010200
07746-0040200
REMOVER SHAFT
REMOVER HEAD
DISTANCE COLLAR
RETAINER
SPEEDOMETER GEAR
DRIVER
PILOT
ATTACHMENT
DUST SEAL
SPEEDOMETER
GEAR BOX
SHIM
DISTANCE
COLLAR
BEARINGS