Clutch Lever - Honda CBR125R Owner's Manual

Install the top bridge.
Install the washer and steering stem nut, but do not
tighten the steering stem nut yet.
Install the fork legs (page 13-25).
Tighten the steering stem left and right, lock-to-lock
several times to make sure the steering stem nut to
the specified torque.
TORQUE: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Turn the steering stem left and right, lock-to-lock
several times to make sure the steering stem moves
smoothly without play or binding.
Install the stay and bolts, tighten the bolts.
Route the wires,
hose and cable
Install the wire harness clamps and brake hose to
properly (page 1-
the stay.
18).
Lift and support the fuel tank.
Connect the ignition switch 2P (Natural) connector.
Close the rubber sheet (page 6-15).
Remove the suitable support and close the fuel tank
(page 3-6).

CLUTCH LEVER

REMOVAL/INSTALLATION
Remove the clutch lever pivot nut and bolt.
Remove the clutch lever and disconnect the clutch
cable.
FRONT WHEEL/SUSPENSION/STEERING
STEERING STEM NUT
CLAMPS
BREAK HOSE
2P (NATURAL) CONNECTOR
PIVOT BOLT
PIVOT NUT
TOP BRIDGE
STAY
BOLTS
CLUTCH LEVER
CABLE
13-31