Flywheel Installation - Honda CBR125R Owner's Manual

INSTALLATION
Install the starter clutch assembly to the flywheel as
shown.
Apply 6.5 ± 0.1 mm (0.26 ± 0.04 in) from tip of lock-
ing agent to the starter clutch torx screw threads.
Install the starter clutch assembly onto the flywheel
and install the torx screws.
Hold the flywheel with a special tool and tighten the
torx screws to the specified torque.
TOOL:
Flywheel holder
TORQUE: 16 N·m (1.6 kgf·m, 12 lbf·ft)
Install the starter driven gear while turning it coun-
terclockwise.
Make sure that the starter driven gear turns counter-
clockwise smoothly and does not turn clockwise.
Install the flywheel (page 11-11).

FLYWHEEL INSTALLATION

Clean any oil from the crankshaft taper.
Install the woodruff key onto the crankshaft.
Be careful not to
damage the key
groove and
crankshaft.
ALTERNATOR/STARTER CLUTCH
STARTER CLUTCH ASSEMBLY
FLYWHEEL
07725-0040001
FLYWHEEL HOLDER
TORX SCREWS
DRIVEN GEAR
WOODRUFF KEY
11-11