Honda CBR125R Owner's Manual page 153

INSTALLATION
Apply engine oil to new O-ring and seal ring.
Install the O-ring and seal ring to the injector, being
careful not to damage them.
Install the injector into the injector joint, being care-
ful not to damage the O-ring.
Align the injector body with the injector joint tab as
shown.
Install the injector assembly to the throttle body.
Be careful not to
Install and tighten the injector joint mounting bolts
damage the seal
alternately to the specified torque.
ring.
TORQUE: 5.1 N·m (0.5 kgf·m, 3.8 lbf·ft)
Connect the injector 2P (Black) connector.
QUICK CONNECT FITTING
INSTALLATION
• Always replace the retainer of the quick connect
fitting when the fuel feed hose is disconnected.
• If any retainer needs replacing, use the same
manufacturer's retainer as the ones being
removed (The various manufactures feature dif-
ferent retainer specifications).
• If any damage or cut-out on the connector
damper, replace it with a new one.
• Do not bend or twist the fuel feed hose.
Connect the injector joint quick connect fitting as
follows:
1. Insert a new retainer into the connector.
• Align new retainer locking pawls with the con-
nector grooves.
FUEL SYSTEM (PGM-FI)
INJECTOR
SEAL RING
INJECTOR
BOLTS 2P (BLACK) CONNECTOR
INJECTOR ASSEMBLY
CONNECTOR Align
INJECTOR JOINT
O-RING
Align
INJECTOR JOINT
RETAINER
5-61