Ect Sensor; Bank Angle Sensor - Honda CBR125R Owner's Manual

ECT SENSOR

REMOVAL/INSTALLATION
Drain the coolant (page 6-7).
Lift and support the fuel tank (page 3-6).
Disconnect the ECT sensor 3P (Gray) connector.
Replace the ECT
sensor while the
engine is cold.
Remove the ECT sensor and sealing washer.
Install a new sealing washer onto the ECT sensor
Always replace a
and install them.
sealing washer with
Tighten the ECT sensor to the specified torque.
a new one.
TORQUE: 24.5 N·m (2.5 kgf·m, 18 lbf·ft)
Connect the ECT sensor 3P (Gray) connector.
Remove the suitable support and close the fuel tank
(page 3-6).
Fill the cooling system with recommended coolant
(page 6-6).

BANK ANGLE SENSOR

REMOVAL/INSTALLATION
Remove the upper cowl (page 2-10).
Remove the mounting screw/washers, collars and
bank angle sensor.
FUEL SYSTEM (PGM-FI)
3P (GRAY) CONNECTOR
ECT SENSOR
SEALING WASHER
ECT SENSOR
BANK ANGLE SENSOR
SCREW/WASHERS
SEALING WASHER
COLLARS
5-63