Turn Signal Lights - Honda CBR125R Owner's Manual

TURN SIGNAL LIGHTS

BULB REPLACEMENT
Remove the screw, washer (CM type only), turn sig-
nal light lens.
While pushing in the bulb, turn it counterclockwise
to remove it.
Replace the bulb with a new one.
Check the packing is installed in position and is in
good condition, replace it with a new one if neces-
sary.
Install the turn signal light lens by aligning the slot
with the tab of the turn signal light.
Install the screw and washer (CM type only).
Tighten the screw to the specified torque.
TORQUE: 0.9 N·m (0.1 kgf·m, 0.7 lbf·ft)
REMOVAL/INSTALLATION
FRONT
Disconnect the turn signal light connectors.
Remove the turn signal light mounting nut and turn
signal light.
Install the turn signal light and turn signal light
Route the wire
mounting nut.
properly (page 1-
18).
Tighten the nut to the specified torque.
TORQUE: 8.8 N·m (0.9 kgf·m, 6.5 lbf·ft)
Connect the turn signal light connectors.
LIGHTS/METERS/SWITCHES
EXCEPT CM TYPE:
PACKING
SCREW
BULB
CM TYPE ONLY:
PACKING
WASHER
SCREW
Align
LENS
NUT
TURN SIGNAL LIGHT
LENS
Align
BULB
CONNECTORS
19-5