Drive in new right crankshaft bearing into the right
crankcase with the marked side facing up until it is
fully seated using the special tools.
TOOLS:
Driver
Attachment, 72 x 75 mm
Pilot, 35 mm
Install the crankshaft (page 12-11).
BALANCER/TRANSMISSION BEARING
Remove the following:
– Crankshaft/balancer (page 12-8)
– Transmission (page 12-12)
RIGHT CRANKCASE SIDE
Remove the bolts and mainshaft bearing setting
plate.
Drive out the mainshaft and balancer bearings.
Remove the countershaft bearing using the special
tools.
TOOLS:
Bearing remover head, 15 mm
Bearing remover shaft
Remover weight
CRANKSHAFT/BALANCER/TRANSMISSION
RIGHT SIDE:
07749-0010000
07746-0010600
07746-0040800
BALANCER BEARING
PLATE
07936-KC10200
07936-KC10100
07741-0010201
WEIGHT
DRIVER
ATTACHMENT
BEARING
MAINSHAFT BEARING
SHAFT
PILOT
BOLTS
HEAD
12-19