Gearshift Linkage - Honda CBR125R Owner's Manual

Attach the clutch center holder to the pressure plate
using the clutch spring bolts to hold the clutch cen-
ter, then tighten the clutch center lock nut to the
specified torque using the special tools.
TOOLS:
Clutch center holder
Lock nut wrench, 20 x 24 mm
Extension bar/handle
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
Install the clutch springs, lifter plate and bolts.
Tighten the lifter plate bolts to the specified torque
in a crisscross pattern in 2 or 3 steps.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the clutch lifter bearing.
Install the right crankcase cover (page 10-8).

GEARSHIFT LINKAGE

REMOVAL
Remove the following:
– Right crankcase cover (page 10-5)
– Clutch assembly (page 10-9)
– Gearshift arm (page 10-18)
Clean the gearshift spindle end.
Remove the shift drum stopper arm bolt and shift
drum stopper arm while holding the shift drum
stopper arm using a screwdriver.
Pull down the spindle arm, then pull out the gear-
shift spindle assembly from the crankcase.
CLUTCH CENTER HOLDER
07GMB-KT70101
07716-0020100
07716-0020500
LOCK NUT WRENCH
BOLTS/SPRINGS
BEARING
SPINDLE ARM
CLUTCH/GEARSHIFT LINKAGE
STOPPER ARM
GEARSHIFT SPINDLE ASSEMBLY
LOCK NUT
LIFTER PLATE
BOLT
10-15