Honda CBR125R Owner's Manual page 187

Install the ground cable and starter motor mounting
bolt.
Tighten the mounting bolt securely.
Install the starter motor cable and starter motor ter-
minal nut.
Tighten the terminal nut securely and reposition the
rubber cap properly on the starter motor terminal.
Connect the spark plug cap and O
ral) connector.
If the O sensor cap is disconnected, replace the O
2
sensor cord with a new one.
Connect the water hoses and tighten the water hose
band screws (page 6-14).
Install the drive chain over the drive sprocket.
Install the drive sprocket to the countershaft.
Install the fixing plate.
Rotate the fixing plate and align the hole in the plate
with the bolt hole in the drive sprocket.
ENGINE REMOVAL/INSTALLATION
BOLT
GROUND CABLE
sensor 2P (Natu-
2
SPARK PLUG CAP
2
DRIVE CHAIN
STARTER MOTOR CABLE
RUBBER CAP
2P (NATURAL) CONNECTOR
WATER HOSES
BAND SCREWS
FIXING PLATE
DRIVE SPROCKET
NUT
Align
7-7