HYDRAULIC BRAKE
ASSEMBLY
RESERVOIR COVER
SET PLATE
DIAPHRAGM
RESERVOIR
Replace the piston, spring and cups as a set.
Apply brake fluid to the master piston sliding area.
Install the spring onto the piston end.
Install the master piston/spring into the master cyl-
Do not allow the
inder.
piston cup lips to
turn inside out.
Apply silicone grease to the push rod contacting
area (page 1-17).
Install the push rod into the master cylinder.
Install the snap ring into the groove of the master
Make sure the snap
cylinder using a special tool.
ring is firmly seated
in the groove.
TOOL:
Snap ring pliers
15-18
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
SPRING
MASTER PISTON
PUSH ROD
07914-SA50001
HOSE JOINT
O-RING
MASTER CYLINDER
BOOT
17 N·m (1.7 kgf·m, 13 lbf·ft)
PIN
BRAKE ROD JOINT
MASTER CYLINDER
SPRING
SNAP RING
PISTON
PUSH ROD
SNAP RING