Honda CBR125R Owner's Manual page 243

CLUTCH/GEARSHIFT LINKAGE
Install the snap ring.
Make sure the snap
ring is firmly seated
in the groove.
SNAP RING
INSTALLATION
Install the left step holder assembly and left step
PINCH BOLT BOLTS
holder mounting bolts, tighten the bolts to the spec-
ified torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the gearshift arm on its original position as
marked during removal.
Install and tighten the pinch bolt securely.
STEP HOLDER ASSEMBLY
Standard pedal height is 53 mm (2.1 in) below the
top of the left step as shown.
53 mm (2.1 in)
GEARSHIFT PEDAL
10-19