ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Drain the engine oil (page 3-14).
Drain the coolant (page 6-7).
Remove the following:
– Middle cowl (page 2-9)
– Gearshift arm and left step holder (page 10-18)
– Throttle body (page 5-52)
– Exhaust pipe/muffler (page 2-13)
– Drive sprocket cover (page 11-4)
Loosen the lock nut and adjusting nut, then discon-
nect the clutch cable from the clutch lifter arm.
Disconnect the alternator/CKP sensor 6P (Natural)
connector and neutral switch wire connector.
Release the alternator/CKP sensor and neutral
switch wires from the clamp.
Loosen the axle nut, lock nuts and adjusting nuts.
Push the rear wheel forward and make a drive chain
slack fully.
Remove the bolts, fixing plate and drive sprocket.
7-4
ADJUSTING NUT
LIFTER ARM
6P (NATURAL) CONNECTOR
NEUTRAL SWITCH WIRE CONNECTOR
AXLE NUT
BOLTS
CLUTCH CABLE
LOCK NUT
CLAMP
LOCK NUT
ADJUSTING NUT
FIXING PLATE
DRIVE SPROCKET