Rear Brake Caliper Removal - Honda 2010 CRF250R Service Manual

INSTALLATION
Install the brake pads (page 15·11).
Install the brake hose eyelet with the brake hose oil bolt
and new sealing washers.
Push the brake hose eyelet joint against the stopper,
then tighten the brake hose oil bolt to the specified
torque.
TORQUE: 34 N'm (3.5 kgf'm , 25 IbHt)
Fill the reservoir to the upper level and bleed the
hydraulic system (page 15-8),
REAR BRAKE CALIPER
REMOVAL
Drain the rear brake hydraulic system (page 15-7).
Remove the brake pads (page 15-13).
loosen the brake hose
oil bolt.
Remove the rear wheel (page 14-7).
HYDRAULIC BRAKE
Remove the brake caliper/bracket assembly to the slide
~~~~==== C=A=L= ' P = E=RI = B= R A = C=K=E= T=A=S=S=E=M =B = L = Y ~
rail of the swing arm.
Remove the brake hose oil bolt. sealing washers and
~~~~~'-~=O " ": I L ~ B ~ O ~ L ~ T ~ ~~~I111~~~
'10 shown:
brake hose eyelet
SEALING WASHERS
"---_ _ __ I L __
~~
15-25