Honda CBR125R Owner's Manual page 389

Install the shim (s) and insulator.
Install the same
Install a new seal ring to the motor case.
number of shim (s)
in the same
Install the lock washer to the front cover.
locations as noted
Install the front cover.
during disassembly.
• When installing the front cover, take care to pre-
vent damaging the oil seal lip with the armature
shaft.
Align the index lines on the covers and motor case.
Install new O-rings onto the motor case bolts.
Install and tighten the starter motor case bolts
securely.
INSTALLATION
Apply engine oil to a new O-ring and install it into
the starter motor groove.
Install the starter motor into the crankcase from the
Route the cable
right side.
properly (page 1-
Install the ground cable and starter motor mounting
18).
bolts.
Tighten the mounting bolts securely.
Install the starter motor cable and starter motor ter-
minal nut.
Tighten the terminal nut securely and reposition
rubber cap properly on the starter motor terminal.
Install the lower cowl (page 2-8).
ELECTRIC STARTER
SEAL RING
SHIM (S) INSULATOR
O-RINGS
BOLTS
O-RING
STARTER MOTOR
STARTER MOTOR
CABLE
BOLTS GROUND CABLE
FRONT COVER
LOCK WASHER
Align
RUBBER CAP
NUT
18-13