Pim Snooping Configuration Example - HP A8800 Configuration Manual

Task
Display PIM snooping
neighbor information.
Display PIM snooping routing
entries.
Display the statistics of
received PIM messages.
Clear the statistics of received
PIM messages.

PIM snooping configuration example

Network requirements
As shown in
multicast data to multicast group 225.1.1.1. Receiver 1 belongs to multicast group 224.1.1.1, and Receiver
2 belongs to multicast group 225.1.1.1. Router C and Router D run IGMP on their interface GigabitEthernet
3/1/1. Router A, Router B, Router C, and Router D run PIM-SM, and interface GigabitEthernet 3/1/2 on
Router A acts as a C-BSR and C-RP.
Configure IGMP snooping and PIM snooping on Router E so that Router E forwards PIM messages and
multicast data to only the routers that are interested in the multicast data.
Figure 19 Network diagram
Configuration procedure
1. Configure an IP address and subnet mask for each interface according to
shown.)
2. On Router A, enable IP multicast routing globally, enable PIM-SM on each interface, and configure
interface GigabitEthernet 3/1/2 as a C-BSR and C-RP.
<RouterA> system-view
[RouterA] multicast routing-enable
Command
display pim-snooping neighbor [ vlan vlan-id ]
[ slot slot-number ] [ | { begin | exclude |
include } regular-expression ]
display pim-snooping routing-table [ vlan
vlan-id ] [ slot slot-number ] [ | { begin | exclude
| include } regular-expression ]
display pim-snooping statistics [ | { begin |
exclude | include } regular-expression ]
reset pim-snooping statistics
Figure 19, Source 1 sends multicast data to multicast group 224.1.1.1, and Source 2 sends
50
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in user view.
Figure 19. (Details not