Displaying And Maintaining Pim Snooping; Pim Snooping Configuration Example - HP 6125XLG Ip Multicast Configuration Manual

Displaying and maintaining PIM snooping

Execute display commands in any view and reset commands in user view.
Task
Display information about PIM snooping neighbors.
Display PIM snooping routing entries.
Display information about PIM snooping router ports.
Display statistics for the PIM messages learned
through PIM snooping.
Clear statistics for the PIM messages learned through
PIM snooping.

PIM snooping configuration example

Network requirements
As shown in
Source 1 sends multicast data to multicast group 224.1.1.1, and Source 2 sends multicast data to
•
multicast group 225.1.1.1. Receiver 1 belongs to multicast group 224.1.1.1, and Receiver 2 belongs to
multicast group 225.1.1.1.
Router C and Router D run IGMP on Ten-GigabitEthernet 1/1/5. Router A, Router B, Router C, and
•
Router D run PIM-SM.
Ten-GigabitEthernet 1/1/6 on Router A acts as a C-BSR and C-RP.
•
Configure IGMP snooping and PIM snooping on Switch A so that Switch A forwards PIM messages and
multicast data to only the routers that are interested in the multicast data.
Figure 16 Network diagram
Figure 16:
Command
display pim-snooping neighbor [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display pim-snooping routing-table [ vlan vlan-id ]
[ slot slot-number ] [ verbose ]
display pim-snooping router-port [ vlan vlan-id ] [ slot
slot-number ]
display pim-snooping statistics
reset pim-snooping statistics
36