Parameter List - Siemens SINAMICS V20 Operating Instructions Manual

Parameter list

8.2 Parameter list
8.2 Parameter list
Parameter Function
r0002 Inverter state
Displays actual inverter state.
0
1
2
3
4
5
6
P0003 User access level
Defines user access level to parameter sets.
0
1
2
3
4
P0004 Parameter filter
Filters parameters according to functionality to enable a more focused approach to commissioning.
0
2
3
5
7
8
10
12
13
19
20
21
22
24
P0005 Parameter display
selection
Selects default display parameter (inverter display).
Example: The inverter displays the value of the parameter selected here by default.
Notice: If you have set P0005 to a non-zero value which represents an actual parameter number, then the inverter
displays the value of the selected parameter as the default display value; if you have set P0005 to 0 or a
non-zero value which does not represent an actual parameter number, then the default display remains
unchanged.
184
Range Factory
default
- -
Commissioning mode (P0010 ≠ 0)
Inverter ready
Inverter fault active
Inverter starting (visible only while pre-charging DC link)
Inverter running
Stopping (ramping down)
Inverter inhibited
0 - 4 1
User defined parameter list - see P0013 for details on use
Standard: Allows access into most frequently used parameters
Extended: Allows extended access, for example, to inverter I/O functions
Expert: For expert use only
Service: Only for use by authorized service, password protected
0 - 24 0
All parameters
Inverter
Motor
Technology application / units
Commands, binary I/O
Analog input and analog output
Setpoint channel / RFG
Inverter features
Motor control
Motor identification
Communication
Warnings / faults / monitoring
Technology controller
List of modified parameters
0 - 9580 0
Can be Scaling
changed
- -
U, T -
U, T -
C, U, T -
Operating Instructions, 11/2016, A5E34559884-006
Data Data Acc.
set type Level
- U16 2
- U16 1
- U16 1
- U16 2
SINAMICS V20 Inverter