Parameter List; Introduction To Parameters - Siemens SINAMICS V20 Operating Instructions Manual

Parameter list

8.1

Introduction to parameters

Parameter number
Numbers prefixed with an "r" indicate that the parameter is a "read-only" parameter.
Numbers prefixed with a "P" indicate that the parameter is a "writable" parameter.
[index] indicates that the parameter is an indexed parameter and specifies the range of
indices available. If the index is [0...2] and the meaning is not listed, then see "Data set".
.0...15 indicates that the parameter has several bits, which can be evaluated or connected
individually.
Data set
Note
The "Index" chapter at the end of this manual provides complete lists of CDS/DDS
parameters.
In the inverter, the parameters which are used to define the sources for commands and
setpoints are combined in the Command Data Set (CDS), while the parameters for the open
and closed-loop control of the motor are combined in the Inverter Data Set (DDS).
The inverter can be operated from different signal sources by switching over the command
data sets. When switching over the inverter data sets, it is possible to switch between
different inverter configurations (control type, motor).
Three independent settings are possible for each data set. These settings can be made
using the index [0...2] of the particular parameter.
Index
[0]
[1]
[2]
SINAMICS V20 has an integrated copy function which is used to transfer data sets. This can
be used to copy CDS / DDS parameters corresponding to the particular application.
Copy CDS
P0809[0]
P0809[1]
P0809[2]
SINAMICS V20 Inverter
Operating Instructions, 11/2016, A5E34559884-006
CDS
Command data set 0
Command data set 1
Command data set 2
Copy DDS
P0819[0]
P0819[1]
P0819[2]
DDS
Inverter data set 0
Inverter data set 1
Inverter data set 2
Remarks
The data set which is to be copied (source)
The data set into which data is to be copied (target)
= 1: Start copying
= 0: Copying completed
8
179