Siemens SINAMICS V20 Operating Instructions Manual page 238

Parameter list
8.2 Parameter list
Parameter Function
P1061[0...2] JOG ramp-down time [s]
Sets ramp-down time. This is the time used while jogging is active.
Dependency: See also P3350, P3353.
Note: See P1060
P1070[0...2] CI: Main setpoint
Defines source of main setpoint.
Setting: 755
1024
1050
P1071[0...2] CI: Main setpoint scaling
Defines source of the main setpoint scaling.
Setting: See P1070
P1074[0...2] BI: Disable additional
setpoint
Disables additional setpoint.
Setting: See P1070
P1075[0...2] CI: Additional setpoint
Defines source of the additional setpoint (to be added to main setpoint).
Setting: See P1070
P1076[0...2] CI: Additional setpoint
scaling
Defines source of scaling for additional setpoint (to be added to main setpoint).
Setting: 1
755
1024
1050
r1078 CO: Total frequency
setpoint [Hz]
Displays sum of main and additional setpoints.
r1079 CO: Selected frequency
setpoint [Hz]
Displays selected frequency setpoint. Following frequency setpoints are displayed:
r1078 Total frequency setpoint
•
P1058 JOG frequency right
•
P1059 JOG frequency left
•
Dependency: P1055 (BI: Enable JOG right) or P1056 (BI: Enable JOG left) define command source of JOG right or JOG
left respectively.
Note: P1055 = 0 and P1056 = 0 ==> Total frequency setpoint is selected.
238
Range Factory de-
fault
0.00 - 650.00 10.00
0 - 1050[0]
4294967295
Analog input 1 setpoint
Fixed frequency setpoint
Motor potentiometer (MOP) setpoint
0 - 1
4294967295
0 - 0
4294967295
0 - 0
4294967295
0 - [0] 1
4294967295
[1] 0
[2] 1
Scaling of 1.0 (100%)
Analog input 1 setpoint
Fixed frequency setpoint
MOP setpoint
- -
- -
Can be Scaling Data
changed set
U, T - DDS
T - CDS
T 4000H CDS
U, T - CDS
T - CDS
T 4000H CDS
- - -
- - -
Operating Instructions, 11/2016, A5E34559884-006
Data Acc.
type Level
Float 2
U32 3
U32 3
U32 3
U32 3
U32 3
Float 3
Float 3
SINAMICS V20 Inverter