Siemens SINAMICS V20 Operating Instructions Manual page 222

Parameter list
8.2 Parameter list
Parameter Function
P0802 Transfer data from
EEPROM
Transfers values from the inverter to external device when P0802 ≠ 0. P0010 must be set to 30 for this to
be possible.
0
2
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
Ensure that enough space exists on the SD card before transferring data (8kb).
P0803 Transfer data to
EEPROM
0
2
3
Transfers parameter values from the SD clone file to the inverter when P0803 ≠ 0. P0010 must be set to
30 to activate this parameter. See P0802 for parameter values.
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
P0804 Select Clone file
Select clone file to upload / download.
if P0804 = 0, then the file name is clone00.bin
if P0804 = 1, then the file name is clone01.bin
etc.
P0806 BI: Inhibit panel access
Binector input to lock control panel access through external client.
r0807.0 BO: Displays client ac-
cess
Binector output to display whether command and setpoint source is connected to an external client.
Bit
00
P0809[0...2] Copy command data set
(CDS)
Calls 'Copy command data set (CDS)' function. The list of all command data sets (CDS) parameters is
shown in "Index" at the end of the manual.
Example: Copying of all values from CDS0 to CDS2 can be accomplished by the following procedure:
P0809[0] = 0 Copy from CDS0
P0809[1] = 2 Copy to CDS2
P0809[2] = 1 Start copy
Index: [0]
[1]
[2]
Note: Start value in index 2 is automatically reset to '0' after execution of function.
222
Range
0 - 2
Disabled
Start data transfer to the SD card
0 - 3
Disabled
Start data transfer from the SD card
Start data transfer from the SD card (except the motor data)
0 - 99
0 -
4294967295
-
Signal name
Master control active
0 - 2
Copy from CDS
Copy to CDS
Start copy
Factory Can be Scaling
default changed
0 C(30) -
0 C(30) -
0 C(30) -
0 U, T -
- - -
1 signal
Yes
[0] 0 T -
[1] 1
[2] 0
Operating Instructions, 11/2016, A5E34559884-006
Data Data Acc.
set type Level
- U16 3
- U16 3
- U16 3
- U32 3
- U16 3
0 signal
No
- U16 2
SINAMICS V20 Inverter