Siemens SINAMICS V20 Operating Instructions Manual page 54

Commissioning via the built-in BOP
5.1 The built-in Basic Operator Panel (BOP)
Normal editing of parameters
Note
Pressing
parameter numbers or indexes is only possible in the parameter menu.
This editing method is best suited when small changes are required to parameter numbers,
indexes, or values.
● To increase or decrease the parameter number, index, or value, press
than two seconds.
● To quickly increase or decrease the parameter number, index, or value, press
for longer than two seconds.
● To confirm the setting, press
● To cancel the setting, press
Example:
Editing parameter values
Digit-by-digit editing
Note
Digit-by-digit editing of parameter numbers or indexes is only possible in the parameter
menu.
54
or for longer than two seconds to quickly increase or decrease the
.
.
SINAMICS V20 Inverter
Operating Instructions, 11/2016, A5E34559884-006
or for less
or