Siemens SINAMICS V20 Operating Instructions Manual page 185

Hide thumbs Also See for SINAMICS V20:
Table of Contents

Advertisement

Parameter
Function
P0007
Backlight delay time
Defines time period after which the backlight of the operator panel display turns off if no buttons have been
pressed.
0
1 - 2000
P0010
Commissioning pa-
rameter
Filters parameters so that only those related to a particular functional group are selected.
0
1
2
29
30
Dependency:
Reset to 0 for inverter to run.
P0003 (user access level) also determines access to parameters.
Note:
P0010 = 1
The inverter can be commissioned very quickly and easily by setting P0010 = 1. After that only the im-
portant parameters (e.g.: P0304, P0305, etc.) are visible. The value of these parameters must be en-
tered one after the other. The end of quick commissioning and the start of internal calculation will be
done by setting P3900 = 1 - 3. Afterwards parameter P0010 and P3900 will be reset to zero automati-
cally.
P0010 = 2
For service purposes only.
P0010 = 30
When resetting the parameters or user default values of inverter P0010 must be set to 30.
Resetting of the parameters will be started by setting parameter P0970 = 1. The inverter will automati-
cally reset all its parameters to their default settings. This can prove beneficial if you experience prob-
lems during parameter setup and wish to start again.
Resetting of the user default values will be started by setting parameter P0970 = 21. The inverter will
automatically reset all its parameters to the factory default settings. Duration of factory setting will take
about 60 seconds.
P0011
Lock for user-defined
parameter
See P0013
P0012
Key for user-defined
parameter
See P0013
SINAMICS V20 Inverter
Operating Instructions, 11/2016, A5E34559884-006
Range
Factory
default
0 - 2000
0
Backlight always on
Number of seconds after which the backlight turns off.
0 - 30
0
Ready
Quick commissioning
Inverter
Download
Factory setting
0 - 65535
0
0 - 65535
0
Can be
Scaling
changed
U, T
-
T
-
U, T
-
U, T
-
Parameter list
8.2 Parameter list
Data
Data
Acc.
set
type
Level
-
U16
3
-
U16
1
-
U16
3
-
U16
3
185

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents