Installing And Configuring Flash Memory Cards In Cisco 3620, Cisco 3640, And Cisco 3660 Routers - Cisco 3600 Series Installation Manual

Chapter 5 Installing Memory in the Router
Perform this procedure to install a Flash memory card:
Step 1 Verify that the Flash memory card's write-protect switch is OFF. The write-protect switch is at the top
left edge of the card, when you view it with the label side toward you. (See
Figure 5-28 Setting the Write-Protect Switch
Flash memory card
write protection
Locate the PCMCIA slots, labeled 1 and 0, at the bottom right corner of the front panel of the chassis.
Step 2
(See Figure 5-29
You can install a single Flash memory card in either slot, and you can install Flash memory cards in
Note
both slots.
For Cisco 3620 and Cisco 3640 routers, insert the connector end of the Flash memory card, label side
Step 3
up, into one of the PCMCIA slots until the card is seated in the connector. (See
In Cisco 3620 and Cisco 3640 routers, the card does not fit completely into the router; part of the
Note
card projects from the slot.
For Cisco 3660 routers, rotate the ejector button outward, and then insert the connector end of the Flash
memory card, label side up, into the PCMCIA slot until the card is seated in the connector. (See
Figure
For Cisco 3660 routers, rotate the ejector button back in, to prevent accidental ejection of the card.
Step 4
OL-2056-02

Installing and Configuring Flash Memory Cards in Cisco 3620, Cisco 3640, and Cisco 3660 Routers

Flash memory card
shown with write
protection off
Flash memory card
and Figure 5-30.)
5-30.)
Figure
Cisco 3600 Series Hardware Installation Guide
5-28.)
Figure 5-29.)
5-35