Displaying The Performance Monitoring Parameters Of A Controller - Cisco ASR 9000 Series System Configuration Manual

Configuring the Performance Monitoring
Thresholds for the Satellite nV Optical System
This chapter describes how to configure the thresholds for Performance Monitoring (PM) parameters of a
controller and display them.
•
•
•
•
•
Displaying the Performance Monitoring Parameters of a
Controller
Depending on the type of a controller, perform any of the following tasks to view the Performance Monitoring
(PM) parameters of the controller. Before viewing the PM parameters, a controller should be created.
Optics Controller
The following command displays the current performance parameters of an Optics controller for 15-minutes
and 24-hour intervals:
show controllers optics R/S/I/P pm current [ 15-min | 24-hour ] optics layer
layer is a number between 1 and 12 depending on the specific hardware whose PM data needs to be displayed.
Here are a few examples:
router# show controllers optics 100/3/0/2 pm current 15-min optics 12
The following commands display the historical performance parameters of an Optics controller for 15-minutes
and 24-hour intervals:
show controllers optics R/S/I/P pm history 15-min optics layer bucket bucket-number
bucket-number is a number between 1 and 32.
show controllers optics R/S/I/P pm history 24-hour optics layer
Displaying the Performance Monitoring Parameters of a Controller, page 125
Configuring the Thresholds for Optics Performance Monitoring Parameters, page 127
Configuring the Thresholds for ODU Performance Monitoring Parameters, page 127
Configuring the Thresholds for OTU Performance Monitoring Parameters, page 129
Configuring the Thresholds for Ethernet Performance Monitoring Parameters, page 130
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
6
C H A P T E R
125