Displaying The Terminating Pvc Connections; Configuring Pvp Connections - Cisco Catalyst 8540 MSR Configuration Manual

Configuring PVP Connections

When configuring the route processor leg of a PVC that is not a tunnel, the VPI should be configured as
0. The preferred method of VCI configuration is to select the any-vci parameter, unless a specific VCI
is needed as a parameter in another command, such as map-list.
If configuring a specific VCI value for the route processor leg, select a VCI value higher than 300 to
Note
prevent a conflict with an automatically assigned VCI for well-known channels if the ATM switch router
reboots.

Displaying the Terminating PVC Connections

To display the terminating PVC configuration VCs on the interface, use the following EXEC command:
Command
show atm vc interface atm
card/subcard/port vpi vci
See
Configuring PVP Connections
This section describes configuring a permanent virtual path (PVP) connection.
example of PVPs configured through the ATM switch routers.
Figure 7-3
User A
To configure a PVP connection, perform the following steps, beginning in global configuration mode:
Command
Step 1 Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Step 2 Switch(config-if)# atm pvp vpi-A [rx-cttr index]
[tx-cttr index] [wrr-weight weight] [sched
sched-A] interface atm card/subcard/port vpi-B
[wrr-weight weight] [sched sched-B]
ATM Switch Router Software Configuration Guide
7-10
Displaying VCCs, page 7-4
Virtual Path Connection Example
Switch B
VPL
VPI = 30
IF# = 4/0/0
Purpose
Shows the PVC configured on the interface.
for examples of the show atm vc commands.
IF# = 0/1/3
Switch C
VPL
VPI = 45
IF# = 1/1/1
PVP
Purpose
Selects the physical interface to be configured.
Configures the interface PVP.
Chapter 7 Configuring Virtual Connections
Figure 7-3
User D
VPL
VPI = 50
IF# = 1/1/0
shows an
OL-7396-01