Table of Contents
Advertisement
3
Ignored Commands
HD – Head Broken Dots Check
This command is used to check the print head for broken dots. This command
is accepted but ignored, because TGL printers do not have the hardware
facilities for checking the thermal head. On TEC printers, data processing is
continued when no broken dots are found. The TGL emulation will always
behave as if no broken dots were found.
RM – Ribbon Motor Drive Voltage Adjust
This command is used to adjust the ribbon motor voltages. It is accepted but
ignored, because TGL printers have a closed loop to control the motor
voltages. Adjustment through host control is therefore not necessary.
WR – Reset
This command resets the printer to its power-on state.
WS – Status Request
This command sends the printer status to the host.
21
Advertisement
Table of Contents
