Table of Contents
Advertisement
Chapter
2
Configuring The LQ-1600K Emulation With Control Codes
Cancel Line
ASCII Code CAN
Hex Code
Dec Code
Purpose
Comment
Cancel Spacing Adjustment
ASCII Code FS V
Hex Code
Dec Code
Purpose
Comment
Carriage Return
ASCII Code CR
Hex Code
Dec Code
Purpose
Comment
28
18
24
Clears all data not yet printed from a line, but does not affect
control codes.
You can use this control code to delete a line, but do so with
caution to avoid possible misprinting. This control code cancels
the double wide attribute set by SO. No other print attributes
are affected. The simulated print head goes to the print position
it had after the last CR or paper motion command.
1C 56
28 86
Cancels the spacing adjustment of half-width characters to fit
into the full-width DBCS character space.
This command cancels the effect of FS U. This control code
does not function while in non-DBCS mode.
0D
13
Returns the simulated print head to the left margin.
The CR code may or may not cause printing or paper motion,
depending on the configuration as set from the control panel. If
CR=CR is set, the characters following the CR are printed over
the previous characters on the line. If CR=CR+LF is set, the
paper is also moved one line at the current line spacing. This
automatic LF will also cancel all single line print attributes.
Advertisement
Table of Contents
