Configuring Martini Vpls; Establishing The Configuration Task - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

7.4 Configuring Martini VPLS

This section describes how to configure Martini VPLS, with the signaling type beling LDP.

7.4.1 Establishing the Configuration Task

Before configuring Martini VPLS, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
When the PE devices support the LDP to be the VPLS signaling, you can configure the Martini
VPLS. PEs must be fully connected to each other through PWs, each of which requires a
dedicated LDP session. As a result, an LDP session must be set up between any two PEs.
As shown in
static peer relationship is established. Therefore, to make PE1 communicate both PE2 and PE3
(but PE2 and PE3 cannot communicate), you only need to specify the peer as PE1 not PE3 on
PE2. The configuration on PE3 is similar.
Figure 7-9 Typical VPLS networking
CE2
Pre-configuration Tasks
Before configuring Martini VPLS, complete the following tasks:
l
l
l
l
Issue 01 (2011-07-15)
Figure 7-9, PE1, PE2, and PE3 are in the same VPLS network. In Martini VPLS,
CE1
PE1
PE2 PE3
Configuring the LSR ID on the PEs and Ps and enabling MPLS and MPLS LDP
Enabling the MPLS L2VPN on the PEs
Establishing the tunnel used to transmit the user data between PEs
Establishing a remote LDP session between the PEs if they are connected indirectly
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
CE3
7 VPLS Configuration
691