Enabling Bfd Globally; Enabling The Sending Of Bfd For Vsi-Pw Packets To The Protocol Stack - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
No.
1
2
3
4

8.4.2 Enabling BFD Globally

Before configuring BFD for VSI PW, you need to enable BFD globally.
Context
Do as follows on routers at both ends of the link to be detected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is enabled on this node and the BFD view is displayed.
----End
8.4.3 Enabling the Sending of BFD for VSI-PW Packets to the
Protocol Stack
To detect VSI PW links by using BFD sessions, the sending of BFD for VSI-PW packets to the
protocol stack must be enabled.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd for vsi-pw enable
The sending of BFD for VSI-PW packets to the protocol stack is enabled.
----End
Issue 01 (2011-07-15)
Data
Name of the management VSI
BFD name
Peer IP address of the VSI PW to be detected by the BFD session
BFD session parameters: local and remote discriminators
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 VPLS Convergence Configuration
808