Huawei quidway s7700 Configuration Manual page 753

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Procedure
Step 1 Configure the VLAN to which each interface belongs according to
The configuration details are not mentioned here.
Step 2 Configure an IGP. In this example, OSPF is adopted.
Configure an IP address for each interface on the PEs and P as shown in
configuring OSPF, advertise 32-bit loopback interface addresses (LSR IDs) of PE1, P, and PE2.
The configuration details are not mentioned here.
After the configuration is complete, run the display ip routing-table command on PE1, P, and
PE2. You can view the routes learned by PE1, P, and PE2 from each other.
Issue 01 (2011-07-15)
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 1/0/0
Configure a routing protocol on the backbone network to implement the interworking
between devices and enable basic MPLS functions.
Set up LSP tunnels between PEs.
Enable MPLS L2VPN on PEs.
Enable BGP peers to exchange the VPLS information between PEs.
Create VSIs on PEs, specify BGP as the signaling protocol, and specify the RD, VPN target,
and site.
Bind VSIs to AC interfaces.
IP addresses of peers
Names of the VSIs on PE1 and PE2
BGP AS numbers on PE1 and PE2
Signaling protocol of a VSI, that is, BGP
RDs, VPN targets, site IDs of VSIs on PEs
Interfaces to which VSIs are bound and VLAN IDs of the interfaces
NOTE
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may occur.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF 30
-
VLANIF 10
VLANIF 40
Figure
7 VPLS Configuration
169.1.1.1/24
2.2.2.9/32
10.1.1.1/24
10.1.1.2/24
7-13.
Figure 7-13. When
738