Creating A Pw Template - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Pre-configuration Tasks
Before configuring the attributes of a PW template, you need to complete the following tasks:
l
l
Data Preparation
To configure the attributes of a PW template, you need the following data.
No.
1
2
3

6.3.2 Creating a PW Template

When configuring PWE3, you can directly specify the IP address of the peer or import a PW
template to set PW attributes.
Context
Do as follows on the PEs on the two ends of the PW.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
Step 3 Run:
quit
Return to the system view.
Step 4 Run:
pw-template pw-template-name
A PW template is created.
----End
Issue 01 (2011-07-15)
NOTE
Some PW attributes such as MTU, PW type, and encapsulation type are obtained from the interface directly
connected to a CE. Therefore, those parameters do not need to be configured manually.
Configuring basic MPLS functions
Enabling MPLS L2VPN
Data
(Optional) Peer IP address
(Optional) Name of the tunnel policy
(Optional) Name and attributes of the PW template
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PWE3 Configuration
552