Configuring Vsi-Based Traffic Suppression - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Figure 7-11 Networking where the VPLS network is deployed over the edge layer
Pre-configuration Tasks
Before configuring the suppression on broadcast traffic based on VSIs, complete the following
task:
Configuring Kompella VPLS or Configuring Martini VPLS
Data Preparation
To configure the suppression on broadcast traffic based on VSIs, you need the following data.
No.
1
2
3
4

7.11.2 Configuring VSI-based Traffic Suppression

Context
Do as follows on the PEs on which the VSI broadcast traffic, multicast traffic, and unknown
unicast traffic need to be suppressed.
Issue 01 (2011-07-15)
Access
UPE
DSLAM
UPE
DSLAM
Data
Name of VSI
Type of the traffic to be suppressed (broadcast, multicast, or unknown unicast)
Committed information rate (CIR), that is, the maximum transmission rate of the
traffic that can pass through
Committed burst size (CBS), that is, the maximum size of traffic that can pass through
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Ethernet Aggregation
UPE
PE-AGG
VPLS
PE-AGG
UPE
7 VPLS Configuration
Edge
NPE
NPE
722