Configuring The Rr To Establish Mp Ibgp Connections With All Client Pes - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
The RR is specified as the BGP peer.
Step 4 Run:
peer ipv4-address connect-interface interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
The IP address of the interface must be the same as the MPLS LSR ID. It is recommended to
specify a loopback interface to establish the TCP connection.
Step 5 Run:
ipv6-family vpnv6
The BGP VPNv6 address family view is displayed.
Step 6 Run:
peer ipv4-address enable
The capability of exchanging IPv6 VPN routes between the Client PE and the RR is enabled.
----End
4.9.3 Configuring the RR to Establish MP IBGP Connections with
All Client PEs
You can configure an RR to establish MP-IBGP peer relationships with all its client PEs. In this
manner, the RR reflects VPNv6 routes for all these PEs.
Context
Choose one of the following schemes to configure the RR to establish MP IBGP connections
with the client PEs.
Procedure
l
Issue 01 (2011-07-15)
Configuring the RR to Establish MP IBGP Connections with the Peer Group
Add all the client PEs to the peer group and establish MP IBGP connection between the
RR and the peer group.
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
group group-name [ internal ]
An IBGP peer group is created.
4. Run:
peer group-name connect-interface interface-type interface-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 BGP MPLS IPv6 VPN Configuration
362