Huawei quidway s7700 Configuration Manual page 212

Smart routing switch

Hide thumbs Also See for quidway s7700:

Table of Contents

Quidway S7700 Smart Routing Switch

Configuration Guide - VPN

Figure 3-5 Networking diagram for configuring mutual access between VPNs

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Configuration Procedure

Step 1 Create VLANs and specify the VLAN IDs that are allowed by the interfaces, as shown in

# Configure PE1.

<Quidway> system-view

[Quidway] sysname PE1

[PE1] vlan batch 10 20

[PE1] interface gigabitethernet 1/0/0

[PE1-GigabitEthernet1/0/0] port link-type trunk

[PE1-GigabitEthernet1/0/0] port trunk allow-pass vlan 10

[PE1-GigabitEthernet1/0/0] quit

[PE1] interface gigabitethernet 2/0/0

Issue 01 (2011-07-15)

This example is only for configuring mutual access for local VPNs on S7700, for details about configuring

mutual access for local VPNs on SPU board, see

Local VPNs on SPU

On the PE, configure a VPN instance, set different VPN targets for the VPN instance

On the PE, bind the interface connected to the CE to the VPN instance.

Enable the routing protocol on the CEs.

VLAN ID and IP address of VLANIF interface allowed by each interface

RD of the VPN

VPN targets of the received and sent routes

Huawei Proprietary and Confidential

3.17.4 Example for Configuring Mutual Access for

VLANIF interface

3 BGP MPLS IP VPN Configuration