Huawei quidway s7700 Configuration Manual page 788

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Create VLANs and add interfaces to the VLANs.
The configuration details are not mentioned here.
Step 2 Set IP addresses.
Set the IP addresses and masks of the interfaces, including VLANIF interfaces and loopback
interfaces, on the UPEs and SPEs according to
The configuration details are not mentioned here.
Step 3 Configure an IGP protocol.
Run OSPF on the SPEs and P to advertise the routes of the network segment and LSR IDs.
# Configure SPE1.
<SPE1> system-view
[SPE1] ospf
[SPE1-ospf-1] area 0
[SPE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SPE1-ospf-1-area-0.0.0.0] network 100.1.1.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] network 100.1.3.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] quit
[SPE1-ospf-1] quit
Issue 01 (2011-07-15)
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure a routing protocol on the backbone network.
Configure the basic MPLS functions on the UPEs and SPEs and set up LSP tunnels.
Configure the MPLS L2VPN capability on the UPEs and SPEs.
Configure dynamic VLLs on the UPEs.
Configure VSIs on the SPEs and configure the SPEs to access VPLS through VLL.
VLANs configured on the interfaces and IP addresses of the interfaces on UPEs and SPEs
Names and IDs of VSIs
MPLS LSR IDs of UPEs and SPEs, which are used as peer IP addresses
Routing protocol
VC ID of the L2VC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF 40
-
VLANIF 50
VLANIF 60
Figure 7-17.
7 VPLS Configuration
100.1.4.2/24
5.5.5.9/32
10.1.1.1/24
10.1.1.2/24
773