Configuring Route Reflection For Bgp Vpnv6 Routes - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
l
----End

4.9.4 Configuring Route Reflection for BGP VPNv6 Routes

Before configuring a BGP VPNv6 RR, ensure that the RR establishes the MP-IBGP peer
relationships with all its client PEs.
Issue 01 (2011-07-15)
The interface is specified as an interface to establish the TCP connection. The IP
address of the interface must be the same as the MPLS LSR ID. It is recommended to
specify a loopback interface to establish the TCP connection.
5. Run:
ipv6-family vpnv6
The BGP-VPNv6 address family view is displayed.
6. Run:
peer group-name enable
The capability of exchanging IPv6 VPN routes between the RR and the peer group is
enabled.
7. Run:
peer ip-address group group-name
The peer is added to the peer group.
Configuring the RR to establish an MP IBGP connection with each client PE
Perform Step 1 to Step 6 repeatedly on the RR to establish an MP IBGP connection between
the RR and each client PE.
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
peer ipv4-address as-number as-number
The client PE is specified as the BGP peer.
4. Run:
peer ipv4-address connect-interface interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
The IP address of the interface must be the same as the MPLS LSR ID. It is
recommended to specify a loopback interface to establish the TCP connection.
5. Run:
ipv6-family vpnv6
The BGP-VPNv6 address family view is displayed.
6. Run:
peer ipv4-address enable
The capability of exchanging IPv6 VPN routes between the RR and the client PE is
enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 BGP MPLS IPv6 VPN Configuration
363