Binding The Vsi Of The Spe With The Vll - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Enter the interface view.
l Ethernet access: Run the interface { ethernet | gigabitethernet | xgigabitethernet }
l VLAN access:
Step 3 Run:
mpls static-l2vc destination ip-address transmit-vpn-label transmit-label-value
receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | [ control-
word | no-control-word ] | [ raw | tagged ] ] *
The static VC is created between the UPE and the SPE devices.
----End

7.6.4 Binding the VSI of the SPE with the VLL

This part describes how to configure an SPE to establish VSI peer relationships with other SPEs,
and with UPEs.
Context
Do as follows on the SPE devices:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
Issue 01 (2011-07-15)
NOTE
The encapsulation modes of the VLL and VPLS must be the same regardless of the access mode.
interface-number command to enter the Ethernet interface view.
– If the UPE supports sub-interfaces, do as follows:
Run the interface { ethernet | gigabitethernet | xgigabitethernet } interface-
number.subinterface-number command to enter the Ethernet interface view.
– If the UPE does not support sub-interfaces, do as follows:
1. Run the vlan vlan-id command to create a VLAN and enter the VLAN view.
2. Run the quit command to return to the system view.
3. Run the interface vlanif vlan-id command to create a VLANIF interface and enter
the VLANIF view.
NOTE
The parameters raw and tagged are needed only for the Ethernet link.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 VPLS Configuration
702