Huawei quidway s7700 Configuration Manual page 515

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
The out-label of PE1 is the same as the in-label of PE2; whereas the in-label of PE1 is the same
as the out-label of PE2.
Procedure
Step 1 Configure interface addresses for CE, PE and P according to
interfaces and VLANIF interfaces.
The configuration procedure is not mentioned.
Step 2 Configure IGP on the MPLS backbone network. (In this example, OSPF is used.)
When configuring OSPF, advertise the 32-bit addresses of loopback interfaces on PEs and P.
The loopback interface addresses are the LSR IDs.
The configuration procedure is not mentioned.
Step 3 Configure basic MPLS functions and LDP on the MPLS backbone network. That is, set up LDP
LSPs.
# Configure PE1.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface vlanif 20
[PE1-Vlanif20] mpls
[PE1-Vlanif20] mpls ldp
[PE1-Vlanif20] quit
# Configure the P.
Issue 01 (2011-07-15)
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Enable MPLS and MPLS L2VPN.
Create a static L2VC connection between PEs and manually configure the VC label.
Labels of the static L2VC connection
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
-
VLANIF 30
VLANIF 20
-
VLANIF 10
VLANIF 40
Figure
5 VLL Configuration
3.3.3.9/32
10.2.2.2/24
10.1.1.2/24
2.2.2.9/32
100.1.1.1/24
100.1.1.2/24
5-6, including VLAN
500