Example For Configuring A Martini Vll - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

5.11.4 Example for Configuring a Martini VLL

Networking Requirements
As shown in
VLANs.
A Martini VLL is set up between CE1 and CE2.
Figure 5-7 Networking diagram for configuring the Martini VLL
GE1/0/0
Device
PE1
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 01 (2011-07-15)
Figure 5-7, CE1 and CE2 are connected to PE1 and PE2 respectively through
Loopback1
1.1.1.9/32
PE 1
GE 2/0/0
GE1/0/0
CE 1
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the routing protocol on backbone devices (PE and P) and enable MPLS.
Use the default tunnel policy to create an LSP and configure the LSP as the tunnel for data
transmission.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1
2.2.2.9/32
GE 2/0/0
GE 1/0/0
P
Martini
VLANIF interface
VLANIF 10
VLANIF 20
-
VLANIF 30
VLANIF 40
-
VLANIF 30
VLANIF 20
-
VLANIF 10
VLANIF 40
5 VLL Configuration
Loopback1
3.3.3.9/32
PE 2
GE1/0/0
GE 2/0/0
GE 1/0/0
CE 2
IP address
-
10.1.1.1/24
1.1.1.9/32
10.2.2.1/24
-
3.3.3.9/32
10.2.2.2/24
10.1.1.2/24
2.2.2.9/32
100.1.1.1/24
100.1.1.2/24
505